Set Up Cisco VPN for Windows

Importing Configurations

The VPN client is configured automatically by the custom installer. However, if you need to import our configuration, follow these instructions:

1. Download the VPN PCF file.
2. Extract the nuvpn.pcf file from the nuvpnpcf.zip file.
3. Select Start => Cisco Systems VPN Client => VPN Client. A window similar to the following will appear:
   

   Cisco VPN For Windows - Main Window (Blank)

4. Click Import. A window similar to the following will appear:
   

   Import Configuration File Step 01

5. Navigate to where the nuvpn.pcf file is located.
6. Select the nuvpn.pcf file, then select Open. A window similar to the following will appear:
   

   Import Configuration File Step 02

7. Click OK.

Network Address Translation (NAT) Configuration for Windows

By default, Network Address Translation (NAT) transparency is turned on. If you use a NAT device (i.e. firewall, personal network snapway, Internet Connection Sharing device) and NAT transparency is turned off, you may need to turn NAT transparency on. One way to tell if you are behind a NAT device is to see if your computer's IP address is 10.x.x.x or 192.168.x.x.

To turn on NAT transparency:

1. Select Start => Cisco Systems VPN Client => VPN Client. A window similar to the following will appear:
   

   Cisco VPN For Windows - Main Window (Full)

2. Select the nuvpn connection entry, then click Modify. A window similar to the following will appear:
   

   Cisco VPN for Windows Properties - Authentication Tab

3. Select the Transport tab. A window similar to the following will appear:
   

   Cisco VPN for Windows Properties - Transport Tab

   1. Select the Enable Transport Tunneling check box.
   2. Select the IPSec over UDP (NAT/PAT) radio button.
   3. Check the Alow Local LAN Access checkbox.
4. Click Save.